← All blog posts

Common mistakes people make with the Sand Calculator

WhiteUI · A plain-English guide to the Sand Calculator

Most wrong sand answers are not arithmetic slips. They are unit slips and measuring slips: depth typed in centimetres, an area measured once and trusted, bags rounded down, or no allowance for sand settling into the ground. The Sand Calculator gives the right answer when the three inputs are right, so the skill is checking the inputs before you trust the number.

At a glance

Same area, wrong depth: 1.2 m³ vs 120 m³Right: 1.2 m³Wrong: 120 m³Typing 10 instead of 0.1 makes the answer 100 times too big
Typing a depth of 10 instead of 0.1 makes the answer 120 cubic metres instead of 1.2 — a hundred times too big.

Mistake 1: depth in centimetres, not metres

A patio 4 metres by 3 metres at 10 centimetres deep needs 4 × 3 × 0.1 = 1.2 cubic metres. Type 10 instead of 0.1 and the tool gives 4 × 3 × 10 = 120 cubic metres, a hundred times too much. The fix is simple: divide centimetres by 100 before you type, so 10 centimetres becomes 0.1 metres.

Mistake 2: rounding the bags down

That same patio needs 1,920 ÷ 25 = 76.8 bags, which the tool rounds up to 77. Rounding down to 76 leaves 20 kilograms short, which is almost a full bag, and a gap in the sand layer. Always round bag counts up, even when the fraction is small.

Mistake 3: measuring the area once

Ground is rarely as flat or as square as it looks. Measure the length and the width in two places each and use the larger figure, or measure the area in sections if it is L-shaped. A patio that is really 5 metres by 4 metres at 0.08 metres deep needs 5 × 4 × 0.08 = 1.6 cubic metres, which is 2.56 tonnes and 103 bags; measuring it as 4.5 by 3.5 metres would give only 1.26 cubic metres, a shortfall of more than a third of a cubic metre.

Mistake 4: no allowance for settling

Sand compacts underfoot and sinks into soft ground, so the finished layer ends up thinner than the depth you poured. Ordering about 10 percent extra covers it: for the 1.2-cubic-metre patio, 1.2 × 1.1 = 1.32 cubic metres, which is 2.11 tonnes and 85 bags. Add the extra before you calculate, by raising the depth a little, rather than guessing after the delivery arrives.

Mistake 5: using the wet-sand weight for dry sand

The tool uses 1,600 kilograms per cubic metre for dry sand. Wet sand can be heavier, so if you weigh sand to check a delivery, a wet cubic metre can read over 1.6 tonnes without anything being wrong. Judge a delivery by volume, not by weight, unless you know the sand is dry.

Worked check

Check any answer against the anchor: 10 square metres at 0.1 metres deep is 1 cubic metre, 1.6 tonnes and 64 bags. If your area is about 10 square metres and your depth is about 0.1 metres, your volume should be near 1 cubic metre. If it is near 10 or near 100, a decimal point has slipped somewhere in the inputs.

Frequently asked questions

What is the most common Sand Calculator mistake?

Typing the depth in centimetres instead of metres. A depth of 10 centimetres must be entered as 0.1, or the answer comes out a hundred times too big.

Should I round sand bags up or down?

Up, always. 76.8 bags means 77 bags, because 76 bags would leave 20 kilograms short.

How much extra sand should I order?

About 10 percent extra covers compaction and uneven ground. For 1.2 cubic metres, order 1.32 cubic metres, which is 85 bags.

How do I check my sand answer quickly?

Compare it with the anchor: 10 square metres at 0.1 metres deep is 1 cubic metre, 1.6 tonnes and 64 bags.

More guides on the Sand Calculator

Try it yourself

Try the Sand Calculator — free, in your browser.

Open the Sand Calculator