← All blog posts

How to calculate stair step by step

WhiteUI · A plain-English guide to stair calculation

A staircase calculation starts from one measurement: the total rise, the vertical height from the lower floor to the upper floor. From that single height, plus your target riser and tread depth, the whole staircase follows — how many steps, how high each one is, and how much floor the staircase occupies.

The steps in order

Steps = total rise ÷ target riser, rounded to the nearest whole step
Actual riser = total rise ÷ steps
Total run = (steps − 1) × tread depth
  • Step 1: divide the total rise by your target riser and round to the nearest whole number of steps.
  • Step 2: divide the total rise by that step count for the actual riser height, so every step is equal.
  • Step 3: multiply the tread depth by one fewer than the step count for the total run.

Worked example: a total rise of 300 cm with a target riser of 18 cm gives 300 ÷ 18 = 16.67, rounded to 17 steps. The actual riser is then 300 ÷ 17 = 17.65 cm, and with a tread depth of 27 cm the total run is (17 − 1) × 27 = 432 cm. A second staircase, 280 cm rise with a 17 cm target, gives 280 ÷ 17 = 16.47, rounded to 16 steps, an actual riser of 17.50 cm and a run of (16 − 1) × 26 = 390 cm with 26 cm treads.

Measure the total rise carefully, from finished floor to finished floor, including any flooring thickness. A centimetre of error in the rise spreads across every step, and uneven steps are the one defect everyone notices on a staircase.

Frequently asked questions

Why round the step count instead of using the exact division?

Because you cannot build a fraction of a step. Rounding gives a whole number of steps, and the actual riser is then adjusted so all steps are equal. Equal risers matter far more than hitting the target exactly.

Why is the total run based on steps minus one?

Because the top step is the upper floor itself: you step from the last tread onto the landing, not onto another tread. Counting an extra tread would overstate the run by one tread depth.

What riser and tread sizes suit a home staircase?

Around 17 to 19 cm with a tread of 25 to 28 cm suits most homes. Local building rules may set limits, so check them before building. This calculator does the geometry, not the regulations.

More guides on the Stair Calculator

Try it yourself

Enter your total rise, target riser and tread depth to see the step count and total run.

Open the Stair Calculator