← All blog posts

All tools / Calculators / Physics / Ohm’s Law Calculator / Ohm's Law for beginners

Ohm's Law for beginners

WhiteUI · A plain-English guide to the Ohm’s Law Calculator

Ohm's law sounds technical, but it describes something you already understand from everyday life: pushing something through a narrow space takes effort, more effort pushes more through, and a narrower space lets less through. In a circuit, voltage is the push, current is the flow, and resistance is the narrowness. This guide starts from zero and builds up with three small examples you can check on a calculator.

A diagram showing 6 volts divided by 3 ohms equals 2 amps, the same current as 12 volts across 6 ohms
6 volts across 3 ohms is 2 amps. Double the voltage and the resistance together, and the current stays the same.

Start with the water picture

Picture water in a pipe. Voltage is the water pressure: the higher the pressure, the harder the water is pushed. Current is how much water flows past a point each second. Resistance is how narrow the pipe is: a narrow pipe holds the flow back. Turn up the pressure and more water flows. Narrow the pipe and less flows. Ohm's law says the same about electricity, in exact numbers: current equals voltage divided by resistance.

Your first calculation

Take a 6-volt battery and a 3-ohm resistor. Divide the voltage by the resistance: 6 ÷ 3 = 2 amps. That is the current flowing through the resistor. Now double both numbers: a 12-volt battery and a 6-ohm resistor gives 12 ÷ 6 = 2 amps again — the same current, because the push and the hold-back grew together. Change only one of them and the answer moves: 12 volts across the same 3-ohm resistor gives 12 ÷ 3 = 4 amps, twice the current, because the push doubled while the resistance stayed put.

A torch battery, worked out

A single AA battery gives 1.5 volts. Connect it to a small bulb with a resistance of 10 ohms and the current is 1.5 ÷ 10 = 0.15 amps. That is 150 milliamps, a small current, which is why a torch battery lasts for hours. The power is 1.5 × 0.15 = 0.225 watts, a fraction of a watt — a torch bulb sips energy, while a heater gulps it. The Ohm's Law Calculator gives the same answer from the same two numbers.

What the answer means, and what it does not

A current of 2 amps does not mean 2 amps are used up. Current flows around the whole circuit and back to the battery; what the resistor uses up is energy, measured in watts, not current. The 2 amps is the rate of flow everywhere in that loop at the same time, like water flowing round a closed pipe. That is why the same current appears on both sides of the resistor.

The common mistake

Beginners most often get the direction of the effect backwards: they expect more resistance to mean more current. It is the opposite. Resistance holds current back, so doubling the resistance halves the current: 12 volts across 6 ohms gives 2 amps, but 12 volts across 12 ohms gives 1 amp. If an answer ever shows current rising when resistance rises, the division went the wrong way round.

Frequently asked questions

What is Ohm's law in simple words?

Current equals voltage divided by resistance. More voltage pushes more current; more resistance lets less through.

What is voltage, current and resistance?

Voltage is the push in volts, current is the flow in amps, and resistance is how much the circuit holds the flow back, in ohms.

What is 6 V across 3 ohms?

6 ÷ 3 = 2 A. Doubling the voltage to 12 V across the same 3 Ω gives 4 A.

Does a resistor use up current?

No. Current flows around the whole circuit. The resistor uses up energy, measured in watts, not current.

More guides on the Ohm’s Law Calculator

Try it yourself

Try the Ohm’s Law Calculator — free, in your browser.

Open the Ohm’s Law Calculator