← All tools/Tools/Home & DIY/Crown Molding Calculator

Crown Molding Calculator

How many crown molding pieces to buy — and how many miter cuts each corner needs.

ft
ft
ft
%

Crown molding runs around the whole ceiling line, so doors are not subtracted. Each corner needs two miter cuts.

Pieces to buy

—

Perimeter
To buy
How the number is worked out

How it works

Perimeter = 2 × (room length + room width).
Total to buy = perimeter × (1 + waste ÷ 100).
Pieces = ceil(total to buy ÷ piece length).
Inside miter cuts = inside corners × 2.
Outside miter cuts = outside corners × 2.

Worked example: a 12 × 14 ft room has a perimeter of 2 × (12 + 14) = 52 ft. With 15% waste that is 52 × 1.15 = 59.8 ft, so 59.8 ÷ 12 = 5 pieces (60 ft bought). Four inside corners need 4 × 2 = 8 miter cuts.

Frequently asked questions

Why is waste higher for crown molding?

Crown molding is cut at an angle, so every corner eats into the piece and a wrong cut wastes a long length. 15% is a sensible default; first-timers should allow 20%.

Why are doors not subtracted?

Crown molding runs around the ceiling line, above the doors, so the full perimeter counts. Baseboard is different — it stops at each doorway.

How many cuts does each corner need?

Two — one on the end of each piece that meets at the corner. Four inside corners therefore mean 8 miter cuts.

What is the difference between inside and outside corners?

An inside corner is where two walls meet inward, like the corner of a room. An outside corner sticks out, like the edge of a chimney breast. Both need two cuts, at opposite angles.

Can I join pieces mid-wall?

Yes, with a scarf joint — a long angled cut that overlaps the two ends. It is far less visible than a straight butt joint, and it is why the waste allowance matters.

More tools

Tell us what you think

Loving this tool, or stuck on something? Tell us — it takes a minute.

We’ll only use your name and email to reply if needed. The tool and page are filled in for you.