← All blog posts

Carpet with units: converting inputs correctly

WhiteUI · A plain-English guide to carpet

Carpet calculations fail on units more than on arithmetic. A length measured in metres and a width measured in centimetres, multiplied together without converting, gives an area 100 times too small — and the resulting order will be useless. The rule is simple: convert everything to one unit before multiplying anything.

The conversions that matter

1 m = 100 cm
Area in m² = length in m × width in m
1 m² ≈ 10.76 sq ft

Take a room measured as 500 cm by 400 cm. Convert first: 5.00 m by 4.00 m, giving 20 m², then 22 m² with 10% waste, then 5.50 m from a 4 m roll. Done the other way — multiplying 500 by 400 and calling the result square metres — the answer would be absurd, which is usually how the mistake gets caught, but not always.

If a shop quotes in square feet, convert the room area rather than the lengths: 20 m² is about 215 sq ft, and 22 m² is about 237 sq ft. Keep the roll width in the same unit as the lengths, and never mix a width in centimetres with a length in metres. One unit, all the way through, is the whole discipline.

Frequently asked questions

Why add a waste allowance at all?

Because cuts, pattern matching and doorways use more carpet than the bare floor area. Ten percent covers most rectangular rooms; an irregular room or a patterned carpet may need more.

Does a narrower roll change how much carpet I need?

No, only the length to order. The area stays the same, but a narrower roll means a longer length off the roll to cover the same floor.

Should I round up when ordering?

Yes. Order the next sensible length above the calculated figure. Carpet is sold by the metre, and running short mid-room is far worse than a small offcut.

More guides on the Carpet Calculator

Try it yourself

Enter your room size, waste allowance and roll width to see how much carpet to order.

Open the Carpet Calculator