← All blog posts

How to use the Body Fat Calculator — step by step

WhiteUI · A plain-English guide to the Body Fat Calculator

The Body Fat Calculator needs four measurements and gives you one number back: your estimated body fat percentage, worked out by the US Navy method. You need a tape measure, a flat wall to stand against for height, and about two minutes. Nothing else is needed.

The four steps

  • Step 1 — Pick male or female. Men and women use different formulas, so tap the right one first. The hip box only matters for women.
  • Step 2 — Height. Type in your height in centimetres, for example 175. Stand barefoot against a wall and mark the top of your head if you are not sure of it.
  • Step 3 — Waist and neck. Measure your waist around the navel, with the tape level and snug but not tight, after breathing out normally. Measure your neck just below the Adam’s apple, with the tape level. For example, waist 85 cm and neck 38 cm.
  • Step 4 — Hip (women only). Measure around the widest part of the hips, with your feet together. For example, 95 cm. Men can leave this box alone — it is not used in the men’s formula.

The result appears straight away: the estimated body fat percentage in large type, with your measurements listed underneath. Change any number and the answer updates at once, so you can see what a centimetre more or less on the waist does to the result.

Worked example

Take a man who is 175 cm tall, with an 85 cm waist and a 38 cm neck. The formula first works out waist minus neck, which is 85 − 38 = 47 cm, then combines that with the height to give 16.94% body fat. The same measurements on the women’s formula, with a 95 cm hip, give 26.83% — the two formulas are different, so never compare a man’s number with a woman’s number.

Man: height 175 cm, waist 85 cm, neck 38 cm
Waist − neck = 85 − 38 = 47 cm
Body fat = 16.94%

At a glance

16.94% on a 0–50% scale0%50%16.94%The marker is the estimate. Most adults land between 10% and 35%.

A man 175 cm tall, waist 85 cm, neck 38 cm: 16.94% body fat. The scale runs to 50% because the calculator’s visual scale does.

The mistake to avoid

The most common slip is measuring the waist in the wrong place — at the belt line, or at the narrowest point, instead of around the navel. A waist measured 2 cm too small can move the answer by about a point and a half, so the navel matters more than the tape. Measure twice, in the same place, and use the second reading if the two differ.

This calculator gives an estimate for information only. It is not medical advice and it does not diagnose anything. If you have a health concern, talk to a doctor or another qualified health professional.

Calculator vs working it out on paper

Working it out on paper teaches you what the calculator is doing; the calculator does it faster and without arithmetic slips. On paper you work through the same steps — waist minus neck, two logarithms, a division, a subtraction — and a careful run takes several minutes plus a calculator for the logs. In the tool you type four numbers and the answer appears.

The two routes should agree, and checking that they do is a good way to learn the method. Take a man 176 cm tall, waist 84 cm, neck 39 cm. Waist minus neck is 45 cm, and the Navy formula gives 15.19% body fat. Work it on paper with the same numbers and you should land on the same 15.19% — if your paper answer differs, the error is in the arithmetic, not in the formula, and the worked example on this page shows each line to compare against.

What to check before you press calculate

Check the sex selection first. The calculator uses a different formula for men and women, and the women’s formula needs a hip measurement the men’s does not. Selecting the wrong one, or leaving the hip box empty on the women’s formula, gives an answer that looks normal but is wrong.

Check the units next. Every box expects centimetres. A height typed in feet, or a waist typed in inches, produces a number that is wildly off — often negative — and the fix is a conversion, not a different formula. One inch is 2.54 cm.

Check the numbers themselves last. Read each box back before you trust the result: a waist of 8 cm instead of 80, or a neck larger than the waist, means a typing slip. The calculator cannot know you meant 84 cm when you typed 48, so a ten-second check saves a wrong answer.

Frequently asked questions

What four measurements does the calculator need?

Height, waist and neck for everyone, plus hip for women. Men use the men’s formula, which needs only height, waist and neck; the hip box is ignored for men.

Where exactly do I measure my waist?

Around the navel, with the tape level and snug but not tight, after breathing out normally. Do not pull the tape in or hold your stomach in.

Do I measure in centimetres or inches?

Centimetres. The calculator takes cm, so type all four measurements in cm. Mixing units gives a wrong answer.

Is 16.94% good or bad?

The calculator gives an estimate, not a verdict. General ranges put men’s fitness roughly at 14–17% and women’s at 21–24%, but a single number is not a health judgement — talk to a doctor if you are concerned.

More guides on the Body Fat Calculator

Try it yourself

A free calculator that estimates body fat percentage from height and tape measurements, using the US Navy method. An estimate, not a medical test.

Open the Body Fat Calculator