← All blog posts

Mulch Calculator for beginners — start here

WhiteUI · A plain-English guide to the Mulch Calculator

If you have never bought mulch before, the only hard part is knowing how much to buy. Too little and the bed is half bare; too much and you have bags sitting in the rain. The Mulch Calculator does the counting for you, and it only needs three numbers. This page explains each one in plain words, with two small examples you can follow with a tape measure.

At a glance

100 litres on a 0 to 500 litre scale0 litres100 litres500 litres2 m² at 5 cm = 100 litres
100 litres sits near the start of a 0 to 500 litre scale — the volume for a 2 square metre bed at 5 centimetres deep.

First: the bed area

The area is how big the bed is, measured in square metres. Walk to the bed with a tape measure, measure the length in metres, measure the width in metres, and multiply them. A bed 2 metres long and 1 metre wide is 2 × 1 = 2 square metres. That is all the area means. If your bed is a circle around a tree, measure the radius instead and use 3.14 × radius × radius, but most beds are rectangles, so length times width is enough.

Second: the depth

The depth is how thick the mulch layer will be, in centimetres. Five centimetres is a thin layer, about the width of two fingers. Seven and a half centimetres is the usual choice for a new bed. Ten centimetres is a thick layer for keeping weeds down. If you are not sure, start with 7.5 — it is the value the tool opens with, and it suits most gardens.

Third: the bag size

Bags of mulch are sold by litres, commonly 40, 50 or 60 litres. The number is printed on the bag. Pick the size you plan to buy, because the tool divides the volume by this number to count the bags. A bigger bag means fewer bags, but the same total volume.

Try one yourself

Take the 2 square metre bed at 5 centimetres deep. The volume is 2 × 5 × 10 = 100 litres. With 40 litre bags, that is 100 ÷ 40 = 2.5, rounded up to 3 bags. Type 2, 5 and 40 into the tool and check that your answers match: 100 litres and 3 bags.

One more example

A bed of 4 square metres at 10 centimetres deep needs 4 × 10 × 10 = 400 litres. With 50 litre bags that is 400 ÷ 50 = 8 bags exactly. Notice the pattern: doubling the depth from 5 to 10 centimetres doubles the mulch, from 200 litres to 400 litres for the same 4 square metre bed.

The common mistake

Beginners often measure the bed in feet and type the number in as metres. A bed 10 feet long is about 3 metres, not 10. If your tape measure reads in feet, divide the feet by 3.28 to get metres first, or measure again in metres.

Frequently asked questions

What is a square metre?

The area of a square 1 metre by 1 metre. A bed 2 metres long and 1 metre wide is 2 square metres.

How deep should mulch be for a beginner?

7.5 centimetres is a good starting point. It is thick enough to hold weeds down without starving the soil of air.

How much mulch for a 2 m² bed at 5 cm?

100 litres, which is 3 bags of 40 litres. The maths is 2 × 5 × 10 = 100, then 100 ÷ 40 = 2.5, rounded up to 3.

What bag sizes does the tool accept?

Any size from 20 to 100 litres. Common shop sizes are 40, 50 and 60 litres.

More guides on the Mulch Calculator

Try it yourself

Try the Mulch Calculator — free, in your browser.

Open the Mulch Calculator